安装探测器是有窍门的，今天我们就来简单的学习一下探测器的安装位置及安装注意事项：
安装位置：
A、探测器安装在被检测气体易漏场所，安装位置根据被检测气体相对于空气比重大小决定。
B、当被检测气体比重大于空气比重时，探测器应安装在距离地面(30～60)cm处，且传感器部位向下。
C、当被检测气体比重小于空气比重时，探测器应安装在距离顶棚(30～60)cm处，且传感器部位向下。
安装注意事项：
为了正确使用探测器及防止探测器故障的发生，请不要安装在以下位置：
A、直接受蒸汽、油烟影响的地方；
B、 给气口、换气扇、房门等风量流动大的地方；
C、水气、水滴多的地方（相对湿度：≥90%RH）；
D、温度在-40℃以下或50℃以上的地方；
E、 有强电磁场的地方。
The installation of the detector is the trick, today we will come to simply learn the installation and installation of the detector.
Installation position:
A, the detectors installed in the detected gas leakage place, according to the installation position relative to the air proportion determines the size of gas is detected.
When the specific gravity of the detected gas is greater than the specific gravity of the air, the detector should be installed at the distance from the ground (30~60) cm and the sensor position is down.
C, when the specific gravity of the detected gas is less than the specific gravity of the air, the detector should be installed at the distance from the ceiling (30~60) cm, and the position of the sensor is down.
Installation note:
In order to use the detector correctly and prevent the failure of the detector, please do not install it in the following position:
A, the place directly affected by steam and oil smoke;
B, air outlet, fan, doors and other large local flow;
C, moisture, water in many places (relative humidity: = 90%RH);
D, the temperature is below -40 C or more than 50 C.
E, where there is a strong magnetic field.